Information Screens - Toro 74060 Software Manual

Screen
The screen displays icons and information relative to
machine operation and is backlit for viewing in low light
situations. The screen is located above the buttons.
Refer to the Screen Icons (page 1)
descriptions.
LED Status Light
The LED status light is multi-colored to indicate the
system status and is located on the right side of the
panel. During startup, the LED illuminates red to
orange to green to verify functionality.
•
Solid Green: indicates normal operating activity
•
Blinking Red: indicates that a fault is active
•
Blinking Green and Orange: indicates that a
clutch reset is required
Buttons
The multi-functional buttons are located at the bottom
of the panel. The icons displayed on the information
screen above the buttons indicate the current function.
The buttons allow you to select the engine speed and
navigate through system menus.
Alarm
If an error occurs, an error message displays, the LED
turns red, and the alarm sounds audibly as follows:
•
A fast chirp sound indicates critical errors.
•
A slow chirping sound indicates less critical errors,
such as required maintenance or service intervals.
Note:
During startup, the alarm sounds briefly to
verify functionality.

Information Screens

The main information screens are as follows:
•
Startup Screen (page 4)
•
Engine-Off Screen (page 4)
•
Engine-On Screen (page 4)
Startup Screen
During startup, the screen displays a startup graphic
for 1 second, sounds the alarm, and illuminates the
LED, changing from red to orange to green.
Engine Screens
Engine-Off Screen
When the key is on without the engine running, the
Engine-Off screen displays
section for icon
Engine-On Screen
When the engine is running, the Engine-On screen
displays
4
Figure 3
1. The screen toggles between hours remaining until the
next required transmission-oil maintenance and gearbox
maintenance (if equipped).
2. Battery voltage display
3. Safety interlock status indicators
4. Engine diesel particulate filter (DPF) soot percentage—The
level is shown on a bar display. The bar graph fills in as
the soot percentage increases. A high soot percentage
indicates that a DPF regeneration may be needed.
5. The screen toggles between hours remaining until
engine-oil maintenance and the non-resettable engine hour
counter.
(Figure 4).
Figure 4
1. Engine speed mode
2. Hydraulic-fluid
temperature
3. Engine temperature
(Figure 3).
g216582
g216584
4. Safety interlock status
indicators
5. Engine speed
6. Recommended engine
cooldown time