Toro 74060 Software Manual page 7

Maintenance and Service Menu by selecting
Yes at the prompt.
Figure 9
1. DPF soot percentage
2. Start Regen
Important:
During a stationary regeneration,
ensure that the machine is parked on a
hard, level surface in a well-ventilated area.
This process runs the machine at a higher
exhaust temperature for approximately 30
minutes to burn off collected particulate in
the DPF.
Note:
You cannot use the machine during a
stationary regeneration.
When the engine ECU determines that a
stationary regeneration is required, the module
displays the Allow Stationary Regen? prompt
screen. Select Y (yes) to start the stationary
regeneration process or N (no) to delay the
process.
Ensure that the machine has at least 1/4
tank of fuel. Disengage the blades, move the
motion-control levers to the N
position, and engage the parking brake.
Figure 10
1. Allow Stationary Regen
2. Yes
•
If you select N (no), the module displays a
120-minute countdown bar graph screen.
g217322
3. Previous
4. Next
-L
EUTRAL OCK
g216640
3. No
1. Stationary Regen Required
If you do not perform a stationary
regeneration before the timer expires, the
engine enters a limp mode and the engine
ECU will require a recovery regeneration to
be performed. When the module indicates
that the engine has entered limp mode, the
engine speed and/or power is reduced and it
prevents clutch engagement.
1. Engine Limp Mode Active
•
If you select Y (yes), the module prompts you
to start the regeneration process
1. Start Regen
A. Shut off the engine and wait for all
moving parts to stop. Ensure that the
machine is on a level surface.
B. Move the control levers to the neutral
lock position and engage the parking
brake.
Note:
or moving the motion-control levers
from the N
7
Figure 11
Figure 12
(Figure
Figure 13
Disengaging the parking brake
-L position at any
EUTRAL OCK
g216641
g216677
13).
g216675