Toro 74060 Software Manual page 10

The following are a list of items available in the Status
of Inputs screen:
•
System voltage
•
Engine communication (highlights if module is
communicating with engine ECU)
•
PTO switch (highlights if pn)
•
Fuel sender voltage (shows voltage)
•
Neutral switch (highlights if on)
•
Brake switch (highlights if on)
•
Seat switch (highlights if on)
•
Oil pressure switch (highlights if on)
•
Engine temperature (shows temperature)
Status of Outputs
This screen lists all of the outputs from the system
and highlights which one is currently active. Outputs
with numerical values display the current value.
1. Status of Outputs
2. Speed Signal
The following are a list of items available in the Status
of Outputs screen:
•
Engine speed signal shows voltage signal sent
from the system to the engine ECU (Engine
Control Unit).
•
PTO output (highlights if on)
•
Engine shutdown output (highlights if on)
•
Module communication (highlights if LDU and
MCU are communicating)
•
Alarm (highlights if on)
•
Starter (highlights if on)
Current Error Messages
This screen displays the current error as text with the
engine hours at which the error occurred. The toggle
button allows you to scroll between screens if multiple
errors are active. If only 1 error occurs, the toggle
button does not change screens.
Figure 23
3. Clutch Output
4. Engine Power to Run
1. Current Error
2. Error display (e.g., Low Oil Pressure)
3. Engine hours when the error occurred
Hydraulic Trans Oil
This service reminder screen displays the hours until
the hydraulic transmission oil maintenance is due.
1. Hydraulic Trans Oil
g038556
2. Reminder display
3. Engine hours remaining until the service is due
Press the toggle button to also display the engine
hours at which every service reminder reset was
performed.
1. Hydraulic Trans Oil
2. Service History display
3. Service reminder reset was performed (e.g., 250 and 750
engine hours)
10
Figure 24
Figure 25
Figure 26
g030185
g030186
g030187