Station Setup; Ap Station Security Settings - Hawking HPOW5CM User Manual

ACM bit:
No ACK policy bit:
When the no acknowledgement (No ACK) policy is used, the recipient does not acknowledge received
packets during wireless packet exchange. This policy is suitable in the environment where
communication quality is fine and interference is weak. While the No ACK policy helps improve
transmission efficiency, it can cause increased packet loss when communication quality deteriorates.
This is because when this policy is used, a sender does not retransmit packets that have not been
received by the recipient. When the Normal ACK policy is used, the recipient acknowledges each
received uncast packet.

5-4 Station Setup

The network manager can configure related wireless settings, AP Setup, Security Settings, and Access
Control Settings.
Administrators can configure ESSID, SSID broadcasting, Maximum number of client associations, security
type settings and MAC Filter settings. (This feature is only available in Client Bridge + Repeater and
WISP Modes)

5-4-1 AP Station Security Settings

ESSID:
Security Type:
Admission Control Mandatory, ACM only takes effect on AC_VI and AC_VO.
When you do not click Checkbox, it means that the ACM is controlled by the
connecting AP. If you click Checkbox, it means that the Client is in charge
Acknowledgment Policy, WMM defines two ACK policies: Normal ACK and No
ACK. Click "Checkbox" indicates "No ACK"
Extended Service Set ID. In station mode, this should be the network you are
connecting to.
Select the desired security type from the drop-down list; the options are Open
System, Shared Key, WPA/WPA2 Personal. Setting should match the network
being connected to.
90