Honda ST1300 2007 Owner's Manual page 174

Main Fuse B
5. Remove the fuse cover.
6. Loosen the screws then replace the fuse.
If you do not have a replacement fuse with the proper rating for the circuit,
install one with a lower rating.
Replacing a f use with one that has a higher rating greatly increases the chance
of damage to the electrical system.
7. After replacing the fuse, tighten the screws.
8. Install the fuse cover and right side cover (page
RIGHT SIDE
If you do not have a spare fuse and you cannot ride the motorcycle without
fixing the problem, take a fuse of the same rating or a lower rating from one of
the other circuits that you can do without temporarily.
If you replace a blown fuse with a spare fuse that has a lower rating, replace the
fuse with the correct rating as soon as you can. Also remember to replace any
spare fuses that were installed.
If the replacement fuse of the same rating burns out in a short time, there is
probably a serious electrical problem on your motorcycle. Leave the blown fuse
in that circuit and have your motorcycle checked by your Honda dealer.
fuse remover
(Canada only)
fuse cover
Taking Care of the Unexpected
If a Fuse Blows
88 ).
main fuse B
blown fuse
167