Honda ST1300 2007 Owner's Manual page 110

Install a New Oil Filter:
5. Remove the oil filter with a filter wrench and let the remaining oil drain out.
Discard the oil filter in an approved manner (page
6. Pour the drained oil into a suitable container and dispose of it in an approved
manner (page
Improper disposal of drained f luids is harmf ul to the environment.
7. Apply a thin coat of engine oil to the rubber seal of a new oil filter.
UNDER ENGINE
oil filter
8. Install the new oil filter and tighten it by hand.
9. Using an oil filter wrench attachment and a torque wrench, tighten the new oil
filter to the specified torque:
20 lbf·ft (26 N·m , 2.7 kgf·m)
10. Check the condition of the sealing washer on the engine oil drain bolt.
Replace the washer every other time the oil is changed.
Install the engine oil drain bolt and tighten it to the specified torque:
22 lbf·ft (29 N·m , 3.0 kgf·m)
145 ).
Engine Oil & Filter
145 ).
rubber
seal
Servicing Your Honda
oil filter
(cont'd)
103