Honda ST1300 2007 Owner's Manual page 173

If a Fuse Blows
4. To check or replace a circuit fuse, pull the old fuse out of its retaining clips
with the fuse remover. Look for a burned wire inside the fuse. If the fuse is
blown, replace it with a spare fuse of the same rating.
If you do not have a replacement fuse with the proper rating for the circuit,
install one with a lower rating.
Replacing a f use with one that has a higher rating greatly increases the chance
of damage to the electrical system.
5. Close the fuse box cover and install the left side cover (page
Main Fuse Access:
Main Fuse A
1. Remove the right side cover (page
2. Disconnect the wire connector of the starter magnetic switch.
3. Pull out the old fuse and install a new fuse.
The spare fuse is located behind the starter magnetic switch.
4. Reconnect the connector.
RIGHT SIDE
wire connector
spare main fuse
166
Taking Care of the Unexpected
88 ).
88 ).
main fuse A