Fcc Regulatory Compliance - Pantech P5000 User Manual

provide the hearing aid user with "normal usage" while using their hearing aid with the particular
wireless phone. "Normal usage" in this context is defined as a signal quality that is acceptable for
normal operation.
The M mark is intended to be synonymous with the U mark. The T mark is intended to be
synonymous with the UT mark. The M and T marks are recommended by the Alliance for
Telecommunications Industries Solutions (ATIS). The U and UT marks are referenced in Section
20.19 of the FCC Rules. The HAC rating and measurement procedure are described in the
American National Standards Institute (ANSI) C63.19 standard.
To ensure that the Hearing Aid Compatibility rating for your phone is maintained, secondary
transmitters such as Bluetooth and WLAN components must be disabled during a call. See Page
62 for instructions to disable these components.

FCC Regulatory Compliance

FCC Regulatory Compliance
This device complies with Part 15 of the FCC Rules. Operation is subject to the following two
conditions: (1) this device may not cause harmful interference, and (2) this device must accept
any interference received, including interference that may cause undesired operation.
Your mobile device is a low power radio transmitter and receiver. When it is ON, it receives and also
sends out radio frequency (RF) signals. In August 1996, the Federal Communications Commission
(FCC) adopted RF exposure guidelines with safety levels for mobile devices. Those guidelines
are consistent with safety standards previously set by both U.S. and international standards
bodies: American National Standard Institute (ANSI), National Council of Radiation Protection
and Measurements (NCRP), and International Commission on Non-Ionizing Radiation Protection
(ICNRP). Those standards were based on comprehensive and periodic evaluations of the relevant
scientific literature. The design of your phone complies with the FCC guidelines and applicable.
01
02
03
04
05
06
07
08
107 107