3. INSTALLATION
3-2. Installing the control box
Wait at least 5 minutes after turning off the power switch and disconnecting the power cord from the wall outlet before
opening the cover of the control box. Touching areas where high voltages are present can result in severe injury.
3-3. Installing the oiler
14
DANGER
Center
KE-430HX/KE-430HS, BE-438HX/BE-438HS
(1) Control box
(2) Bolts [4 pcs]
(3) Plain washers [4 pcs]
(4) Spring washers [4 pcs]
(5) Nuts [8 pcs]
3859B
Before installing the oiler, provisionally
install the rubber cushion (1) and the
hinge holder (2) to the table with the two
bolts (3).
(4) Dust oiler support
(5) Wood screws [2 pcs]
(6) Plain washers [2 pcs]
(7) Oiler
* Install the dust oiler support (4) so that
the hole (8) in the dust oiler support (4)
is in the center of the hole (9) in the
table for installing the oiler (7) as shown
in figure [A].
NOTE:
• Make sure that the dust oiler support
(4) does not interfere with the hinge
holder (2).
3752B