Auxiliary Heat / Electric Heat Setup; Compressor Lockout Temperature - Bard CompleteStat CS9B-THO,CompleteStat CS9B-THOCCompleteStat CS9BE-THO,CompleteStat CS9BE-THOC Installation & Operation Manual

20. Enter button to highlight current economizer selection
21. Up/Down buttons to choose from available Economizer options:

None = No Economizer, or Standard Vent. Pkg. (ERV/CRV/MFAD)

En/Dis (Engage/Disengage) = Economizer in system
22. Enter button to select/save appropriate economizer options
23. Left arrow back to additional setup
24. Down button to locate & highlight Valve (if HP was chosen)
25. Enter button to select/enter Valve (if HP was chosen)
26. Right button to highlight Valve options (if HP was chosen)
27. Up/Down buttons to choose from Valve options: (if HP was chosen)

ACTIVE HTG

ACTIVE CLG
28. Enter button to save Valve option choice (if HP was chosen)
29. Left button (6x) to navigate back to home page
Auxiliary Heat/Electric Heat Setup – If a heat pump is chosen, then the
electric heat strips must be configured. These steps do not apply to air
conditioners or other types of conventional heating. To configure the
auxiliary heat from the home screen, press:
1. Right button to access the Main Menu screen
2. Down button through entries to highlight Advanced
3. Enter button to select Advanced and enter Advanced Screen
4. Enter button again to select/enter Applications Screen
5. Controller will ask for Admin Level Password
Factory Default Admin Level Password: BARD
Press Enter
6. Down button through entries to highlight Additional Setup
7. Enter button to select/enter Additional Setup Screen
8. Enter button again to select/enter Aux Heat
9. Enter button again to highlight Aux Heat choices
10. Up/Down buttons to toggle through available choices...
 W/O Lockout – Auxiliary heat will activate regardless of compressor operation or outdoor air temperature (factory default)
- If W/O Lockout is chosen, proceed to set delay-on time
 Comp Lockout – Compressor locks out below the selected Outdoor Air Temperature. (Requires optional 8301-
061 Outdoor Air Temperature Sensor.)
 None – no auxiliary strip heat, controller will not energize W2
- If None is chosen, Left button (5x) to return to home screen
11. Down button to highlight Delay (mins)
12. Enter button to highlight default Delay minutes
13. Up/Down buttons to select the amount of minutes you would like to delay the electric heat before activation.
14. Enter button to save choice.
15. Left button (5x) to return to home screen.
Compressor Lockout Temperature – If you have chosen auxiliary heat strip configuration "Comp Lockout," an
optional outdoor air temperature sensor will have to be installed/configured to specifically set the temperature at
which the compressor will no longer be allowed to operate. To install the 8301-061 Outdoor Air Temperature
Sensor, attach the leads to terminals "OAT" and "GND." To set the compressor outdoor air temperature from
the home screen, press...
1. Right button to access the Main Menu screen
2. Down button through entries to highlight Advanced
3. Enter button to select Advanced and enter Advanced Screen
4. Down button through entries to highlight Limits
5. Enter button to select Limits and enter Limits Screen
6. Down through entries to highlight Comp OAT Low
7. Enter button to select current Comp OAT Low setting
8. Up/Down button to desired outdoor air temperature for compressor lockout
2100-566D
Page 5 of 20