Fiat Radio 3.0 Manual page 30

If seven Bluetooth audio devices
have already been paired to the
vehicle, pairing cannot be performed
and "MEMORY FULL" is displayed.
Delete one paired device to pair
another one.
Pairing A Bluetooth Audio
Device Which Does Not Have A
Four-Digit PIN Code
Proceed as follows:
A Using the audio control dial, select
the pairing mode "PAIR DEVICE"
in the "BT SETUP" mode. (refer to
"Bluetooth Audio Set Up" for
details).
B Press the audio control dial to
determine the mode. After "ENTER
PIN" is displayed on the audio
display for three seconds, "PIN
0000" is displayed and the PIN code
can be input.
C Press the audio control dial while
"PIN 0000" is displayed. "PAIRING"
flashes on the audio display.
D Operate the Bluetooth audio device
and set it to the pairing mode while
"PAIRING" is flashing.
E As the Bluetooth audio device
requires a PIN code, input "0000".
F When the pairing is completed, a
music note and "PAIR SUCCESS"
are displayed after about
10-30 seconds, after which "PAIR
SUCCESS" continues to be
displayed for three seconds, and
then the unit returns to the normal
display.
Note:
If pairing cannot be completed, try
"1234" instead. Refer to the owner's
manual of your mobile device for
the right PIN code.
Some Bluetooth audio devices
need a certain amount of time before
the symbol is displayed.
If the pairing failed, "Err" flashes for
three seconds.
Pairing cannot be performed while
the vehicle is moving. If you attempt to
perform pairing while the vehicle is
moving, "PAIR DISABLE" is displayed.
If seven Bluetooth audio devices
have already been paired to the
vehicle, pairing cannot be performed
and "MEMORY FULL" is displayed.
Delete one paired device to pair
another one.
Device Selection
If several devices have been paired, the
Bluetooth unit links the device last
paired. If you would like to link a
different paired device, it is necessary to
change the link.
The order of device priority after the link
has been changed is maintained even
when the ignition is switched off.
Proceed as follows:
A Using the audio control dial, select
the link change mode "LINK
CHANGE" in the "BT SETUP" mode
(refer to "Bluetooth Audio Device
Set-Up" for details).
B Press the audio control dial to
determine the mode.
C The name of the currently linked
Bluetooth audio device is displayed.
If no Bluetooth audio device is
currently linked, the name of the first
device among the paired devices
is displayed.
D Turn the audio control dial to select
the name of the device you would
like to link.
29