Fiat Radio 3.0 Manual page 29

Bluetooth Audio Device Pairing
Any Bluetooth audio device must be
paired to the vehicle's Bluetooth unit
before it can be listened to over the
vehicle's speakers.
A maximum of seven devices including
Bluetooth audio devices and hands
free mobile phones can be paired
to one vehicle.
Note:
If a Bluetooth device has already
been paired to the vehicle as a
hands-free mobile phone, it does not
need to be paired again when using
the device as a Bluetooth audio
device. Conversely, it does not need to
be paired again as a hands-free mobile
phone if it has already been paired as
a Bluetooth audio device.
Device registration can also be
done using voice recognition.
Concerning the operation of a
Bluetooth audio device itself, refer to its
instruction manual.
Some Bluetooth audio devices have
PIN codes (four digits). Refer to the
audio device's instruction manual
because the pairing procedure differs
depending on whether it has a PIN
code or not.
28
Pairing A Bluetooth Audio
Device Which Has A Four-Digit
PIN Code
Proceed as follows:
A Using the audio control dial, select
the pairing mode " PAIR DEVICE " in
the "BT SETUP" mode. (refer to
"Bluetooth Audio Device Set-Up" for
details).
B Press the audio control dial to
determine the mode. After "ENTER
PIN " is displayed on the audio
display for three seconds,
"PIN 0000" is displayed and the PIN
code can be input.
C Input the PIN code of your Bluetooth
audio device by pressing channel
preset buttons 1 to 4 while "PIN
0000" is displayed. Press channel
preset button one to input the
first digit, two for the second, three
for the third, and four for the forth.
For example, if the PIN code were
"4213" press channel preset button
"one" four times (one, two, three,
four), button "two" twice (one, two),
button "three" once (one), and
button "four" three times (one, two,
three). If the "PIN 0000" display
disappears before finishing the PIN
code input, repeat the procedure
from Step A.
Note: Some devices accept only a par-
ticular pairing code (Usually, "0000" or
"1234"). If pairing cannot be completed,
refer to the owner's manual of your
mobile device, and try those numbers if
necessary.
D Press the audio control dial while the
input PIN code is displayed.
"PAIRING" flashes on the audio
display.
E Operate the Bluetooth audio device
and set it to the pairing mode while
"PAIRING" is flashing.
F When the pairing is completed, a
music note and "PAIR SUCCESS"
are displayed after about
10-30 seconds, after which "PAIR
SUCCESS" continues to be
displayed for three seconds, and
then the unit returns to the normal
display.
Note:
Some Bluetooth audio devices
need a certain amount of time before
the music note symbol is displayed.
If the pairing failed, "Err" flashes for
three seconds.
Pairing cannot be performed while
the vehicle is moving. If you attempt to
perform pairing while the vehicle is
moving, "PAIR DISABLE" is displayed.