Table of Contents
Advertisement
O P E R A T I N G Y O U R V E H I C L E
TURN SIGNAL/WIPER/WASHER/HIGH BEAM LEVER
The multifunction lever is located on the left side of the steering column.
Multifunction Lever
Turn Signals
Move the multifunction lever up or down and the arrows on each side of the instrument
cluster flash to show proper operation of the front and rear turn signal lights.
NOTE:
If either light remains on and does not flash, or there is a very fast flash rate, check for a
defective outside light bulb. If an indicator fails to light when the lever is moved, it would
suggest that the indicator bulb is defective.
When the Daytime Running Lights are on and a turn signal is activated, the Daytime
Running Lamp will turn off on the side of the vehicle in which the turn signal is flashing.
The Daytime Running Lamp will turn back on when the turn signal is turned off.
Lane Change Assist
Tap the lever up or down once, without moving beyond the detent, and the turn signal
(right or left) will flash three times then automatically turn off.
High/Low Beam Switch
Push the multifunction lever toward the instrument panel to switch the headlights to high
beams. Pulling the multifunction back toward the steering wheel will turn the low beams
back on, or shut the high beams off.
Windshield Wipers And Washers
The windshield wiper/washer controls are located on the multifunction lever on the left
side of the steering column. The front wipers are operated by rotating a switch, located on
the end of the lever. For information on the rear wiper/washer, refer to "Rear Window
Wiper/Washer" in this section.
45
Advertisement
Table of Contents
