Table of Contents
Advertisement
G E T T I N G S T A R T E D
Driver Memory Seat — If Equipped
This feature allows the driver to store up to two different memory profiles for easy recall
through a memory switch. Each memory profile contains desired position settings for the
driver seat, side mirrors, adjustable pedals (if equipped), and power tilt and telescopic
steering column (if equipped) and a set of desired radio station presets. Your Remote
Keyless Entry (RKE) transmitter can also be programmed to recall the same positions
when the UNLOCK button is pushed.
NOTE:
Your vehicle is equipped with two RKE transmitters, one RKE transmitter can be linked to
memory position 1 and the other transmitter can be linked to memory position 2.
The memory seat switch is located on the driver's door trim panel. The switch consists of
three buttons:
• The (S) button, which is used to activate the memory save function.
• The (1) and (2) buttons which are used to recall either of two pre-programmed memory
profiles.
Programming The Memory Feature
NOTE:
To create a new memory profile, perform the
following:
1. Cycle the vehicles ignition to the ON/
RUN position (Do not start the engine).
2. Adjust all memory profile settings to
desired preferences (i.e., seat, side mir-
ror, power tilt and telescopic steering
column [if equipped], and radio station
presets).
3. Push and release the S (Set) button on
the memory switch.
4. Within five seconds, push and release
either of the memory buttons (1) or (2). The Driver Information Display (DID) will
display which memory position has been set.
NOTE:
• Memory profiles can be set without the vehicle in PARK, but the vehicle must be in
PARK to recall a memory profile.
• To set a memory profile to your RKE transmitter, refer to "Linking And Unlinking The
Remote Keyless Entry Transmitter To Memory" in this section.
32
Memory Seat Buttons
Advertisement
Table of Contents
