Disassembly Procedure - Roland R-09 Service Notes

Apr. 2006

Disassembly Procedure

Detaching the BOTTOM PANEL
1.
The bottom panel is secured in place with double-sided tape at the
location shown by dotted lines in the figure. Peel off carefully in the
direction of the arrow.
* The bottom panel may deform or crack. In such cases, placing a part order for a
bottom panel is required.
fig.bottom-panel_85
Detaching the TOP CASE and
BOTTOM CASE
2.
Remove the screws at the three locations shown in the figure.
fig.top-case-screw_85
8
3.
Place so that the top panel is at the top, then lift up the top case to remove.
fig.top-case-remove_85
Detaching the TOP BOARD
4.
Because this is secured in place by a circuit board to circuit board
connector, grasp and remove the top board without applying twisting
force to the connector.
fig.top-board-remove_85
Detaching the CENTER BOARD
and BOTTOM BOARD
5.
Turn upside-down, use tweezers or the like to flip up the lock tabs at the
circled areas, then remove the BATTERY HOLDER while disengaging the
locks.
fig.battery-holder_85
R-09