Roland R-09 Service Notes page 15

Apr. 2006
Exiting Test Mode
1.
While in Test mode, hold down the [FINDER/MENU] button and press
the [ ] button several times to move to "12. Factory Reset."
The next screen appears.
fig.test12-1_90
2.
Press the [REC] button to execute Factory Reset.
fig.test12-2_90
When processing finishes, the screen automatically changes. If an SD
card is inserted, a screen like the one shown below appears.
fig.test13-1_90
3.
Eject the SD card, and when a screen like the one shown below appears,
switch off the power.
fig.test13-2_90
When the power is off and the screen has gone completely blank, disconnect
the AC adaptor.
Skipping test items
To move among the test items, use the [
to proceed to the next without executing tests for any items, hold down the
[FINDER/MENU] button and use the [
selection.
Test Items
In Test mode, you perform testing for the following items.
1. Checking Version
2. Device Test
3. Analog (External Mic) Test
4. Analog (LINE) Test
5. Recording and Playing
6. Switch/LED Test
Display Test
7.
8. USB Test
9. Digital Out Test
10. Analog (Internal Mic) Test
11. Noise Test
12. Factory Reset
1. Checking Version
Entering Test mode displays the version-confirmation screen.
fig.test01-1_90
Prog: Program version and relevant information
Bootup program version
Boot:
Updt: Update program version
After verifying the version, use the [
R-09
] and [ ] buttons. If you want
] and [ ] buttons to make the
] button to advance to the next item.
15