Function Options By Pressing Two Buttons And The Service Socket - Meyra Sprint Special Operating Instructions

LCD OPERATING DEVICE, CODE 416

Function options by pressing two buttons and the service socket

The service socket facilitates changes in direction as well as the direction of steering in the case of the
sprint models.
Changing direction
There is a choice of travelling "forwards" (standard setting) or "reverse" when the wheelchair's drive lever is
moved forwards.
Some users find it easier to pull the drive lever backwards rather than push it forwards. This group of
users has the option of travelling forwards by pulling the drive lever backwards, i.e. towards them.
Steering of the wheelchair is unaffected by this.
Handling:
– Insert the service plug in the control box service socket and switch on the wheelchair.
– Press the "Hazard light" and the "ON/OFF" buttons at the same time.
The change in direction is activated once the wheelchair is switched on again.
Available from microprocessor "IC1.0 W" (approx. October1996) in the LCD board in the control
box.
Changing the steering direction when reversing
It is possible for the wheelchair to move like a standard dual-motor wheelchair when reversing:
Drive lever moved backwards to the left
> Curving towards the back right, or like a standard single-motor wheelchair:
Drive lever moved backwards to the left
> Curving towards the back left.
Handling:
– Insert the service plug in the control box service socket and switch on the wheelchair.
– Press the "MODE" and the "ON/OFF" buttons at the same time.
The change in direction is activated once the wheelchair is switched on again.
Available from microprocessor "IC1.0 W" (approx. October1996) in the LCD board in the control
box.
9