Lan Cable Connection (For Operation Management) - Fujitsu ETERNUS AF250 S2 Configuration Manual

Chapter 5 General Settings
5.5

LAN Cable Connection (for Operation Management)

9
Remove the LAN cable that connects the RMT port to the PC terminal.
5.5 LAN Cable Connection (for Operation Management)
The ETERNUS AF must be connected to a LAN to perform actions via ETERNUS Web GUI or ETERNUS CLI such
as settings, maintenance operations, monitoring the device status, and using remote support.
Prepare the required number of LAN cables for the network environment of the customer.
The following procedure explains how to connect the LAN cable.
When the LAN switch that is to be used has the Spanning Tree Protocol (STP) function enabled, connection
to the ETERNUS AF may fail. Use the following settings to disable the STP function:
When the STP function is not necessary for the network configuration:
•
Disable the STP function of the LAN switch.
When the STP function is necessary for the network configuration:
•
Disable the STP function of the LAN switch port only for the ETERNUS AF connection or perform the Port-
Fast setting.
• To help with LAN cable management and prevent incorrect connections, attach labels to the LAN cables
and make a note of connection origins and destinations.
When connecting LAN cables, check the connector orientation and then firmly push it all the way in.
•
When disconnecting LAN cables, depress the tab, then pull out the connector.
1
Connect the LAN cable to the ETERNUS AF.
Connect the LAN cable connectors to the MNT ports of the Controller 0 (CM#0) and Controller 1 (CM#1)
for the ETERNUS AF.
Do
When connecting the LAN cables, position them so that they will not obstruct
•
replacement of the power supply unit or controllers by the maintenance engi-
neer.
FUJITSU Storage ETERNUS AF250 S2, ETERNUS AF250 All-Flash Arrays Configuration Guide (Basic)
Copyright 2017 FUJITSU LIMITED
70
P3AG-1832-04ENZ0