Connecting Spring-Loaded Terminals - Siemens SIWAREX JB Compact Operating Instructions

5.4.4

Connecting spring-loaded terminals

Figure 5-6
In order to connect the spring-loaded terminals, you require a screwdriver with a maximum
blade width of 2.5 mm.
1. Strip the insulation from the cables as shown.
2. Push the screwdriver into the rectangular opening
3. Insert the stripped wire into the round opening as far as the stop
4. Remove the screwdriver from the rectangular opening
The use of spring-loaded terminals ensures that the contact pressure being exerted is
permanently maintained.
Note
The use of spring-loaded terminals ensures that the contact pressure being exerted is
permanently maintained.
SIWAREX JB stainless steel with ATEX certificate
Compact Operating Instructions, 06/2010, A5E01257284C-01
Pin assignment of the spring-loaded terminals
8 - 9 mm
Figure 5-7 Strip cable
This opens the spring clip of the spring-loaded terminal.
Figure 5-8 Connection of spring-loaded terminals
The spring clip firmly holds the stripped wire and establishes the contact.
Installing and connecting
①
.
②
.
③
.
5.4 Connection
17