Setting The System - Sharp LC-45GX6U Operation Manual

Preparation

Setting the System

After putting the Display and the AVC System in place, connect the system cables and AC cords. Use the
cable clamps for bundling the cables.
1
Removing the terminal cover
2
Connecting the system cable and the AC cord to the Display
AC cord
3
Connecting the system cable and the AC cord to the AVC System
AVC System (rear view)
CAUTION
• TO PREVENT RISK OF ELECTRIC SHOCK, DO NOT TOUCH UN-INSULATED PARTS OF ANY CABLES WITH THE
AC CORD CONNECTED.
NOTE
* When you unplug the WHITE system cable, make sure you unscrew the screws thoroughly before unpluging the
cable.
** When you unplug the GRAY system cable, press the hooks on both sides of the cable inward as you unplug the cable
gently.
Display (rear view)
(BLACK)
Connect the plug
completely.
(BLACK)
Press the two hooks
toward the center of the
Display and remove the
cover toward you.
Press down the four
upper hooks to remove
the cover toward you.
(WHITE)*
Connect the plug into the terminal
and secure it by tightening the
thumb screws.
System cable
(GRAY)**
Connect the plug firmly until the
hooks on both sides click.
System cable
(WHITE)* (GRAY)**
AC cord
11