Installing/Removing The Battery; Installing The Battery - Datamax OC2 BT Technical Manual And User Manual

Figure5

Installing/removing the battery

Note: The battery is already installed in new printers. See
"Removing the battery isolator" on page 2 for information on
enabling the battery in a new printer.

Installing the battery

1. Press the printhead cover release and open the printer, as
shown in Figure 8.
2. Remove any packaging material (if applicable).
3. Position the battery with its contacts facing toward the
battery cavity, as shown in Figure 9.
Figure8
4. Lower the battery into the battery cavity, fitting the
contact end of the battery into the cavity first, as shown in
Figure 10.
5. Slide the battery all the way to the right in the battery
cavity so that the edge of the battery hits the battery stop,
as shown in Figure 11. The printer beeps one time when
you install the battery. Figure 12 shows the fully seated
battery.
S
ETTING UP YOUR PRINTER
Figure6 Figure7
Figure10
Figure9
3