Roam Request; To Start A Roam Request - Motorola CDM1550 LS+ User Manual

ROAM REQUEST

Because of the RSSI feature, the
CDM1550•LS
different site when the signal from the
registered site becomes too weak for quality
communication. This RSSI threshold is
programmed by your dealer. However, if you
believe the signal strength would be better on
another site, you may want to manually initiate
the roaming process. This feature is called
Roam Request.

To Start a Roam Request

1 Press the preprogrammed Roam
Request button (see page 25).
2 When the radio is searching for a new
site or attempting successful registration
to a site, you see on the display:
42
English
+
radio automatically roams to a
SEARCHING
3 When the radio has successfully regis-
tered to the new PassPort System, you
see on the display:
REG SITE XXX
Note: A bad key chirp may sound and you
see on the display:
Roam Not Avail
• When registration to a site with a
higher RSSI than your current site is
unavailable.
• When the preprogrammed button is
pressed before the radio has collected
its "neighbor list". A Neighbor list" is a
list of frequencies from adjoining sites
within the PassPort system that are
used during the roam process.
• When the radio is programmed for a
single home system.
In these cases, wait a few seconds and
try again.