Printer is Making Unusual Noises
Probable Causes
There is an obstruction or debris inside the printer.
Paper Tray Will Not Close
Probable Causes
The paper tray does not fully close.
Condensation Has Formed Inside the Printer
Moisture can condense in the printer when room humidity exceeds 85% or when a cold printer is located
in a warm room. Condensation can form in a printer after it has been sitting in a cold room that is heated
quickly.
Probable Causes
The printer has been sitting in a cold room.
The relative humidity of the room is too high.
®
®
Xerox
VersaLink
B605/B615 Multifunction Printer
User Guide
Solutions
Power off the printer, then remove the obstruction or
debris. If you cannot remove the obstruction, contact
your Xerox representative.
Solutions
• If the tray is extended for legal-size paper, the tray
protrudes when it is inserted into the printer. For
more information, refer to
for the Paper
Length.
• Some debris or an object is blocking the tray.
• The tray is blocked by the table or shelf on which it
is located.
• If the paper lift plate at the back of the tray is not
locked down, replace the tray.
Solutions
Allow the printer to operate for several hours at room
temperature.
• Reduce the humidity in the room.
• Move the printer to a location where the temperature
and relative humidity are within the operating spe-
cifications. For more information, refer to
mental
Specifications.
Troubleshooting
Configuring Trays 1 or 2
Environ-
8-5