Table of Contents
Advertisement
2.2. Connecting the MyWirelessTV Transmitter
You should install the Transmitter near the video source device (settop box, Blu-ray player,
gaming console, etc.). Follow the procedure below to set up the MyWirelessTV transmitter:
1.
Select the source device (i.e. a Cable/Satellite set-top box or Blu-ray player) you wish to
transmit signal to the TV, and power off that device. Get the Wireless HD Video
Transmitter unit from MyWirelessTV 3 Kit box.
2.
(Optional) If the source device is previously connected to an HDTV, unplug the HDMI
cable from the back of the source, and then plug the free end of the HDMI cable into
theHDMI OuttoTVport on the back of the Transmitter.
3.
Otherwise, get an HDMI cable from MyWirelessTV 3 Kit box. Plug one end into the
HDMI Input port on the back of the Transmitter.
4.
Plug the other end into an HDMI port on the source device.This cable should now
connect the Transmitter to the sourcedevice.
5.
Get one power supply from the MyWirelessTV kit box and plug the connector of the
power cord into the 5VDC / 2A (Power) port on the Transmitter. Plug the AC adapter of
the power supply into a power outlet.
6.
Verify that the POWER LED is solid green.
7.
Turn on the HDTV and the video source device, and make sure you can see video from
your sourcedevice.
2.3. Connecting the MyWirelessTV Receiver
You should install the Receiver near the HDTV monitor where you intendto watch the
content being streamed from the source device.
1.
Get the Wireless HD Video Receiver, HDMI cable and power supply. Go to the TV that
you want to connect.
Draft
6
Advertisement
Table of Contents
