ActionTec MWTV3TX User Manual page 7

LINK LED. The LINK LED isused to display the state of pairing between the

Transmitterand Receiver. If it is blinking or off, the Transmitter is not paired with any
Receiver. If it is glowing steadily, it has paired witha Receiver.
POWER LED. The Power LED isused to display the state of the Receiver's power. If

unlit, the device is off.If lit, the device is on.
USBport. The USB port is used toconnect a USB stick drive to the Receiver when a

firmware update isavailable. See "错误！未找到引用源。" for more details.
MENU and SELECT buttons. The MENU and SELECT buttons are used together to

access the GUI menu. Pressing the MENU button selects an option, and pressing the
SELECT button saves the setting. And you can reset the receiver by holding the MENU
button for more than five (5) seconds and then releasing the button.
Note: You can access the GUI menu when the receiver has connected to the
transmitter or when the receiver has not paired with any transmitter.
Power Port. The 5V DC / 2A power portisused to connect the Receiver to a power

source.
HDMI Out to TV Port. The HDMI Out to TVport isused, via an HDMI cable, to connect

the Receiver to an HDMI-readydisplay, such as a high-definition TV.
IR Ext Port. The IR Ext portis used toconnect the IR Receiver cable, used to extend the

range of the sourcedevice's remote control (in conjunction with the IR Blaster
cableconnected to the Transmitter).
Note: The use of the IR Receiver Extension Cable is optional.
Draft
4