Part II. Connecting MyWirelessTV 3
Connecting MyWirelessTV consists of two parts: connecting theTransmitter to a source of
high-definition video, and connecting thereceiver to a high-definition television monitor. This
chapter will take youthrough both procedures, as well as setting up the IR Blaster and
IRReceiver to allow you to use the remote control of the source device in thelocation you are
watching (or playing) your content.
2.1. Typical MyWirelessTV Connection Configuration
2.1.1. Transmitter
A typical connection for the Transmitter is shown below:
Note: Connecting a TV to the HDMI Out to TV port is optional.
2.1.2. Receiver
A typical connection for the Receiver is shown below:
5
Draft