Table of Contents
Advertisement
4
Setup Program
The Home Wireless Gateway setup program is Web-based,
which means that it is accessed through your Web browser
running on your Windows or Macintosh computer. Make
sure that your gateway and modem are powered up before
performing the following procedure.
Accessing the Setup Program
1 Launch your Web browser on one of your networked
computers.
When the gateway is powered up, it will attempt to
automatically collect the networking setup information
from your Internet Service Provider (ISP). If you get access
to the Internet, the gateway has received this required
information from your ISP, and 3Com recommends that
you perform step 2, below, and then change your
password and update your time zone immediately (see
"Change your password." on page 22).
If your Web browser informs you that you cannot access
the Internet, continue to follow this procedure.
2 Type the following Internet Protocol (IP) address in
the location or address field of your browser:
192.168.2.1 (Figure 9)
Figure 9 Web Browser Location Field
R
UNNING THE
P
ROGRAM
S
ETUP
Advertisement
Table of Contents
