Advertisement
Thermostat Installation
1. Viewing the refrigerator from the rear, mount the thermostat to the right condenser fin.
Remove wires from the plastic bag. Untangle any wires that are connected to the thermostat
and the fan. Align the holes of the thermostat with the left slot in the condenser fin. See Figures
2 and 6.
IMPORTANT: The thermostat is fragile, handle it with care. Do not hit the plastic thermostat
with the screwdriver or allow the screwdriver to slip off the screw and contact the plastic.
NOTE: The 41" red wire goes to the left terminal. The 60" red wire (and attached fuse holder)
goes to the right terminal.
2. Insert a #8 x 3/8" screw through the bottom hole of the thermostat and into the lowest point of
the left condenser fin slot. Tighten the screw 1 or 2 turns to hold the thermostat in place. See
Figure 6.
3. Insert a #8 x 3/8" screw through the top hole of the thermostat and into the condenser fin slot.
See Figure 6.
4. Tighten the screws to secure the thermostat to the condenser fin.
IMPORTANT: Do not overtighten the screws.
Figure 6
6
Advertisement
