Advertisement
3. Slide mounting brackets along the absorber coils. Leave a 3" clearance between the right
edge of the brackets and the cooling unit's return tube. See Figure 5.
4. Tighten 1 1/4" mounting bracket screws securing bracket to cooling system. See Figure 5.
5. Place 12 VDC fan on top of the mounting bracket B (label side up) and fan wires exiting to the
left side (when viewed from the back).
Insert two 2" fan mounting screws and tighten to secure fan to mounting bracket. See Figure 4.
Do not over tighten, causing plastic fan housing to crack. Ensure fan wires do not contact
the sharp edges of the bracket or are pinched in any way.
NOTE: When installing fan, leave remaining wires in plastic bag to prevent them from pinching.
Figure 5
5
Advertisement
