Installing/ Removing The Optional Battery Pack - Kenwood TK-5400 Instruction Manual

KENWOOD CORPORATION

Installing/ Removing the Optional Battery Pack

The battery pack is not charged at the factory; charge it before use.
CAUTION:
DO NOT RECHARGE THE BATTERY PACK IF IT IS ALREADY FULLY CHARGED. DOING SO MAY CAUSE
◆ ◆ ◆ ◆
THE LIFE OF THE BATTERY PACK TO SHORTEN OR THE BATTERY PACK MAY BE DAMAGED.
AFTER RECHARGING THE BATTERY PACK, DISCONNECT IT FROM THE CHARGER. IF THE CHARGER
◆ ◆ ◆ ◆
POWER IS RESET (TURNED ON AFTER BEING TURNED OFF), RECHARGING WILL START AGAIN AND THE
BATTERY PACK WILL BECOME OVERCHARGED.
DO NOT SHORT THE BATTERY TERMINALS OR DISPOSE OF THE BATTERY BY FIRE.
◆ ◆ ◆ ◆
NEVER ATTEMPT TO REMOVE THE CASING FROM THE BATTERY PACK.
◆ ◆ ◆ ◆
1 Match the four grooves of the battery pack with the corresponding guides on the back of the transceiver.
2 Slide the battery pack along the back of the transceiver until the release latch on the base of the transceiver locks.
3 To remove the battery pack, pull back on the release latch and slide the pack away from the transceiver.
PREPARATION
FCC ID: ALH33063110