Table of Contents
Advertisement
Maintain the Prism III Printer
3. Install the supply roller as shown. Leave some slack in the ribbon leader.
a. Press the operator
button until the printer
tray comes out. The
ribbon is threaded to the
front of the Prism.
b. Remove the ribbon
leader from the
installation clamp.
c. Remove the adhesive
strip from the ribbon
leader.
4. Load the take-up roller.
a. Place the new empty cardboard core on the take-up roller. It is
designed to fit only one way.
b. Place the take-up roller on top of the ribbon leader as shown.
Important! The gear must be on the correct side.
Gear
Adhesive Strip
2001809_A
SHORT TERM CONFIDENTIAL
Supply Roller
Cardboard Core
Ribbon Leader
For more information visit
c. Pull the ribbon leader up over the cardboard core.
d. Attach the adhesive strip to the cardboard core so that the edges
on the ribbon leader are aligned to the edges of the cardboard core.
Note: The arrow in the
photo illustrates the
wrap direction.
e. Roll the ribbon leader
so that it is wrapped
only once around the
roller.
Important! Do not roll past the marking on the leader that states
STOP - Wind Leader Onto Take-up Core Stopping Here for
monocolor ribbons. If you are using a CMY ribbon, roll up to the end
of the yellow leader.
rimage.com/support
19
Hide quick links:
Advertisement
Table of Contents
