Wiring Connection - Kenwood KDC-220UI Instruction Manual

INSTALLATION/CONNECTION

Wiring connection

Antenna terminal
Connecting the ISO connectors on some VW/Audi or
Opel (Vauxhall) automobiles
You may need to modify the wiring of the supplied wiring
harness as illustrated below.
A7 (Red)
Vehicle
A4 (Yellow)
Default wiring
Pin Color and function
A4 Yellow : Battery
1
A5 Blue/White* : Power control
A7 Red : Ignition (ACC)
A8 Black : Earth (ground) connection
B1 Purple ]
: Rear speaker (right)
B2 Purple/black [
B3 Gray ]
: Front speaker (right)
B4 Gray/black [
B5 White ]
: Front speaker (left)
B6 White/black [
B7 Green ]
: Rear speaker (left)
B8 Green/black [
Output terminals
Ignition wire (Red)
Unit
Battery wire (Yellow)
Yellow (Battery wire)
Red (Ignition wire)
ISO
connectors
Fuse (10 A)
If no connections are made, do not let the wire come out from the tab.
Light blue/yellow
(Steering remote
control wire)
2
Blue/White*
(Power control wire/
Antenna control wire)
Red (A7)
Yellow (A4)
Brown
(Mute control wire)
NOTE: Total output for Blue/White wire (*
If your car does not have an ISO terminal:
We recommend installing the unit with a commercially
available custom wiring harness specific for your car and
leave this job to professionals for your safety. Consult
your car audio dealer.
When connecting to an external amplifier, connect
its ground wire to the car's chassis to avoid damaging
the unit.
STEERING WHEEL
REMOTE INPUT
To the steering wheel remote control adapter
REMOTE CONT
To the power control terminal when using the
ANT CONT
optional power amplifier or to the antenna control
P. CONT
terminal in the vehicle
To the terminal that is grounded when the telephone
rings or during conversation ( 17)
MUTE
(To connect the Kenwood navigation system, refer
your navigations manual.)
1 2
) + (* ) is 12 V 350 mA
15
ENGLISH