Installation/Connection Specifications - Kenwood KDC-BT730DAB Instruction Manual

INSTALLATION/CONNECTION
7 Remove the film covering the earth sheet and paste the earth sheet on the metal part
of the vehicle.
Provide sufficient leeway for the earth sheet so that it does not interfere with the interior parts
(front pillar cover). Also take care that the interior parts do not interfere with the amplifier unit
(G).
Windscreen
(G)
Front pillar cover
8 Wire the antenna cables.
Use cable clamper (H) to secure the antenna to the pillar at several positions.
9 Attach the front pillar cover back to its original position.
Be sure not to damage the earth sheet and amplifier unit (G) when covering.
10 Connect the amplifier unit (G) to the DAB antenna jack on the rear of the unit.
11 Set [DAB ANT POWER] to [ON]. (Page 4)
Earth sheet
SPECIFICATIONS
DAB Frequency Range
Sensitivity
Signal-to-Noise Ratio
Antenna Connector Type
Antenna Output Voltage
Antenna Maximum Current
FM Frequency Range
Usable Sensitivity (S/N = 30 dB)
Quieting Sensitivity (DIN S/N = 46 dB)
Frequency Response (±3 dB)
Signal-to-Noise Ratio (MONO)
Stereo Separation (1 kHz)
MW Frequency Range
(AM)
Usable Sensitivity (S/N = 20 dB)
LW Frequency Range
(AM)
Usable Sensitivity (S/N = 20 dB)
Laser Diode
Digital Filter (D/A)
Spindle Speed
Wow & Flutter
Frequency Response (±1 dB)
Total Harmonic Distortion (1 kHz)
Band III 174.928 MHz — 239.200 MHz
–100 dBm
90 dB
SMB
12 V DC
< 100 mA
87.5 MHz — 108.0 MHz (50 kHz space)
6.2 dBf (0.56 μV/75 Ω)
15.2 dBf (1.58 μV/75 Ω)
30 Hz — 15 kHz
68 dB
40 dB
531 kHz — 1 611 kHz (9 kHz space)
28.5 μV
153 kHz — 279 kHz (9 kHz space)
45 μV
GaAIAs
8 times over sampling
500 rpm — 200 rpm (CLV)
Below measurable limit
20 Hz — 20 kHz
0.01 %
37
ENGLISH