Restoring To Defaults ( Reset ); All Reset; Set Mode Reset - Yaesu FT-70DR Operating Manual

Restoring to Defaults ( Reset )

All Reset

To restore all transceiver settings and memory content to the factory defaults.
Resetting the transceiver will clear all memories.
Please make a note of the memories ( memory channel settings, etc ) before resetting.
1. Turn the transceiver OFF.
2. Press and hold the [ MODE ] key, the [ HM/RV ]
key and the [ AMS ] key and turn the transceiver
ON simultaneously.
The beep sounds and the confirmation
screen is displayed.
3. Press the [ F ] key.
• The beep will sound, and the transceiver
will reset all factory defaults.
• After resetting all defaults, the call sign
input message appears on the LCD. Set
the call sign (
To cancel the resetting, press any key except the [ F ] key.

Set Mode Reset

All the Set mode only, settings can be restored to the default settings.
1. Turn the transceiver OFF.
2. Press the [ MODE ] key and the [ V/M ] key and
turn the transceiver ON simultaneously.
The beep sounds and the confirmation
screen is displayed.
3. Press the [ F ] key then the beep sounds and
all Set mode settings are reset to defaults.
Perform All Reset to restore all of the following Set Mode items to default.
1 ANT.ATT
17 DP-ID
37 PAG.ABK
46 RPT.FRQ
62 W/N.DEV
To cancel the resetting, press any key except the [ F ] key.
38
CAUTION!
14 ) .
8 BELL
19 DT SET 33 MEM.NAM 35 NM/FRQ
38 PAG.CDR 39 PAG.CDT
47 RX MOD 49 SCM.WTH 50 SCV.WTH
64 MYCALL
9 BNK.NAM 11 CLK.SFT
41 PSWDWT
FT-70DR/FT-70DE Operating Manual
13 DCS.INV
36 OPN.MSG
44 RF SQL
54 SQL.EXP