Table of Contents
Advertisement
Your new tiller has been assembled at the factory with exception of those parts left unassembled for shipping purposes.
To ensure safe and proper operation of your tiller all parts and hardware you assemble must be tightened securely. Use
the correct tools as necessary to insure proper tightness.
TOOLS REQUIRED FOR ASSEMBLY
A socket wrench set will make assembly easier. Standard
wrench sizes are listed.
(1) Utility knife
(1) Tire pressure gauge
(1) Pair of pliers
(1) 9/16" wrench
OPERATOR'S POSITION (See Fig. 1)
When right or left hand is mentioned in this manual, it
means when you are in the operating position (standing
behind tiller handles).
(2) Handle Lock
(1) Flat Washer 13/32 x 1 x 11 Ga.
(1) Hairpin Clip
ASSEMBLY
CONTENTS OF HARDWARE PACK
(1) Carriage Bolt
3/8-16 UNC x 1 Gr. 5
(1) Cable Clip
(1) Pivot Bolt
3/8-16 UNC Grade 5
4
FRONT
LEFT
RIGHT
OPERATOR'S
POSITION
FIG. 1
(1) Center Locknut
3/8-16 UNC
(1) Handle Lock Lever
(2) Shear Pins & Clips
Advertisement
Table of Contents
