Nose Piece - Stanley ProSet XT1 Blind Rivet Tool Original Instruction

E N G L I S H
FITTING INSTRUCTIONS
IMPORTANT - READ THE SAFETY WARNINGS LISTED IN THE PROSET XT1 AND PROSET XT2 INSTRUCTION
MANUAL CAREFULLY BEFORE PUTTING INTO SERVICE.
IMPORTANT - THE AIR SUPPLY MUST BE TURNED OFF OR DISCONNECTED BEFORE FITTING OR
REMOVING THE NOSE EQUIPMENT.
Item numbers in bold refer to the components in figure 3 & 4 and the tables on pages 8 & 9.
• The air supply must be disconnected.
• Rotate Nose Housing (2) anti-clockwise and remove together with Nosepiece (1).
• Rotate Jaw Guide (3) anti-clockwise and remove together with Jaws (4).
• Remove Jaw Pusher (5) together with Urethane Washer (6), Jaw Pusher Spring (7) from Pulling Head (8).
• Remove Mandrel Guide (9) from Pulling Head (8).
• Insert "adapted Mandrel Guide" (9), Jaw Pusher Spring (7), Urethane Washer (6) and "adapted Jaw Pusher"
(5) to Pulling Head (8).
• Lightly coat Jaws (4) with moly lithium grease.
• Drop Jaws (4) into the Jaw Guide (3).
• Pull back Jaw Guide Lock (10) and screw Jaw Guide (3) fully on to Pulling Head (8).
• Release Jaw Guide Lock (10) and then partially unscrew Jaw Guide (3) until Jaw Guide Lock (10) tooth
clicks into the next slot on Jaw Guide (3).
• Rotate Nosepiece (1) anti-clockwise and remove from Nose Housing (2).
• Replace with the Nosepiece (1) specified for the rivet to be placed.
• Screw Nose Housing (2) together with Nosepiece (1) to tool.
• The tool is now ready to place the required rivet.
SERVICING INSTRUCTIONS
• Nose Equipments need to be serviced at weekly intervals or every 3,000 cycles. Hold some stock of all
internal components of Nose Equipment and Nosepieces, they need regular replacement.
• The air supply must be disconnected.
• Remove Nose Housing (2), including Nosepiece (1), and O-Ring (13) from the tool.
• Pull back Jaw Guide Lock (10) against Jaw Guide Lock Spring (11) and then remove Jaw Guide (3).
• Remove the Jaws (4) from Jaw Guide (3).
• Remove Jaw Pusher (5), Urethane Washer (6), and Jaw Pusher Spring (7), from Pulling Head (8).
• Rotate Lock Nut (12) anti-clockwise and remove Pulling Head (8), Jaw Guide Lock (10), Jaw Guide Lock
Spring (11) from the tool piston using spanners.
• Inspect all components. Any worn or damaged parts must be replaced by a new part.
• Particularly check wear Jaws (4).
• Clean all parts and apply moly lithium Grease (07992-00020) to Jaws (4) and taper bore of Jaw Guide (3).
• Assemble according to fitting instructions above.
10