Checking The Configuration - Huawei Quidway S9300 Configuration Manual
Terabit routing switch
Hide thumbs
Also See for Quidway S9300:
- Configuration manual - network management (630 pages) ,
- Configuration manual (603 pages) ,
- Configuration manual - multicast (262 pages)
Table of Contents
Advertisement
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
The system view is displayed.
Step 2 Run:
ip vpn-instance vpn-instance-name
The VPN instance view is displayed.
Step 3 Run:
tnl-policy policy-name
The tunnel policy is applied to the VPN instance.
----End
1.6.5 Checking the Configuration
Prerequisite
The configurations of L3VPN tunnel binding are complete.
Procedure
l
l
l
l
l
----End
Example
Run the display tunnel-policy command. If the bound tunnel interface is displayed in the output
information, it means that the configuration is successful. For example, there is a tunnel interface
in the tunnel policy, and the destination address is the same as the configured destination address.
<Quidway> display tunnel-policy policy1
Tunnel Policy Name
---------------------------------------------------------------------
policy1
Run the display interface tunnel command. You can see that the bound tunnel is Up. The
following is an example:
<Quidway> display interface tunnel 1/0/0
Tunnel1/0/0 current state : UP
Line protocol current state : UP
Description : HUAWEI, Quidway Series, Tunnel1/0/0 Interface, Route Port
The Maximum Transmit Unit is 1500 bytes
Internet Address is unnumbered, using address of LoopBack1(1.1.1.9/32)
Encapsulation is TUNNEL, loopback not set
Tunnel destination 2.2.2.9
Tunnel protocol/transport MPLS/MPLS, ILM is available,
primary tunnel id is 0x10002, secondary tunnel id is 0x0
Issue 01 (2009-07-28)
Run the display tunnel-policy policy-name command to view the configurations of tunnel
policies.
Run the display interface tunnel interface-number command to view information about
the bound tunnel interface.
Run the display ip vpn-instance verbose [ vpn-instance-name ] command to display the
tunnel policy applied to VPN instances.
Run the display ip routing-table vpn-instance vpn-instance-name [ destination-
address ] verbose command to display the tunnels used by the routes of VPN instances.
Run the display tunnel-info tunnel-id command to display information about a tunnel.
Destination
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
Tunnel Intf
2.2.2.9
Tunnel1/0/0
3.3.3.9
Tunnel2/0/0
1 VPN Tunnel Management
Down Switch
Disable
Disable
1-19
Advertisement
Table of Contents
