Configuring The Tunnel Policy Applied To L3Vpn (Select-Sequence); Establishing The Configuration Task - Huawei Quidway S9300 Configuration Manual

1 VPN Tunnel Management
Run the display tunnel-info command, and you can see the tunnel ID and other information as
follows:
<Quidway> display tunnel-info all
* -> Allocated VC Token
Tunnel ID
----------------------------------------------------------------------
0x20002
0x10001
0x10002
0x10004
You can run the display tunnel-info tunnel-id command to obtain detailed information about
the tunnel.
<Quidway> display tunnel-info 0x20002
Tunnel ID:
Tunnel Token:
Type:
Destination:
Mask:
Out Slot:
Instance ID:
Interface:
Sub Tunnel ID:
1.4 Configuring the Tunnel Policy Applied to L3VPN
(Select-Sequence)
This section describes how to configure the tunnel policy in select-sequence mode and how to
apply the policy to the L3VPN.

1.4.1 Establishing the Configuration Task

1.4.2 Configuring the Tunnel Policy
1.4.3 Applying the Tunnel Policy on L3VPN
1.4.4 Checking the Configuration
1.4.1 Establishing the Configuration Task
Applicable Environment
By default, the S9300 selects LSPs for a VPN and load balancing is not performed. If load
balancing or other types of tunnels are required, you need to configure a tunnel policy and bind
the tunnel policy to a tunnel.
For L3VPNs, tunnel policies are applied to VPN instances.
The tunnel policy in select-sequence mode includes the policy for selecting tunnels and the
number of tunnels carrying out load balancing. In practical scenarios, tunnel policies are valid
in the same Autonomous System (AS).
1-8
300 seconds input rate 31776024 bytes/sec, 31776152 packets/sec
300 seconds output rate 31776024 bytes/sec, 31776152 packets/sec
185 packets input, 19714 bytes
0 input error
184 packets output,
0 output error
Type
cr lsp
lsp
lsp
lsp
Huawei Proprietary and Confidential
Copyright © Huawei Technologies Co., Ltd.
19738 bytes
Destination
3.3.3.3
100.1.1.2
2.2.2.2
192.168.2.0
0x20002
115712
cr lsp
3.3.3.3
0.0.0.0
1
0
Tunnel1/0/1
0x0
Quidway S9300 Terabit Routing Switch
Configuration Guide - VPN
Token
115712
0
1
3000
Issue 01 (2009-07-28)