Example: Verifying The Ethernet Ring Protection Configuration - Cisco NCS 4200 Series Configuration Manual

Example: Verifying the Ethernet Ring Protection Configuration

bridge-domain 1002
!
End
Example: Verifying the Ethernet Ring Protection Configuration
The following is sample output from the show ethernet ring g8032 configuration command. Use this
command to verify if the configuration entered is valid and to check for any missing configuration parameters.
Device# show ethernet ring g8032 configuration
ethernet ring ring0
Port0: GigabitEthernet0/0/0 (Monitor: GigabitEthernet0/0/0)
Port1: GigabitEthernet0/0/4 (Monitor: GigabitEthernet0/0/4)
Exclusion-list VLAN IDs: 4001-4050
Open-ring: no
Instance 1
Description:
Profile:
RPL:
Inclusion-list VLAN IDs: 2,10-500
APS channel
Level: 7
Port0: Service Instance 1
Port1: Service Instance 1
State: configuration resolved
LAN Switching Configuration Guide, Cisco IOS XE Everest 16.6.1 (Cisco NCS 4200 Series)
32
opp
ITU-T G.8032 Ethernet Ring Protection Switching