Resetting Ports - Cisco NCS 4200 Series Configuration Manual

UniDirectional Link Detection (UDLD) Protocol
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2 configure terminal
Example:
Router# configure terminal
Step 3 udld recovery inteval
Example:
Router(config)# udld recovery
Step 4
end
Example:
Router# end

Resetting Ports

SUMMARY STEPS
1. enable
2. udld reset
3. end
DETAILED STEPS
Command or Action
Step 1
enable
Example:
Router> enable
Step 2
udld reset
Example:
Router(config)# udld reset
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Enters global configuration mode.
Enables UDLD recovery on the router.
• inteval—Sets the recovery time interval. The valid range
is from 30 to 86400 seconds. The default value is 300
seconds.
Returns to privileged EXEC mode.
Purpose
Enables privileged EXEC mode.
Enter your password if prompted.
Resets ports that are shut down by UDLD.
LAN Switching Configuration Guide, Cisco IOS XE Everest 16.6.1 (Cisco NCS 4200 Series)
Resetting Ports
7