Initial Power On Test; Troubleshooting - Raymarine CP200 Installation Instructions Manual

6.1 Initial power on test

Once the unit has been correctly installed check that
it is operating correctly.
After powering on, the unit will take approximately 50
seconds to start up. From powering on through to
normal operation, the LED status indicator should be
green. If the LED status indicator is not green then
refer to the troubleshooting section of this handbook.
Open the Fishfinder application on your connected
multifunction display and ensure that it is operating
correctly.
Switching the active sonar module
If you have multiple sonar modules on your network
you can select which sonar module will be active in
the Fishfinder application.
From the Fishfinder application:
1. Select Menu.
2. Select Sounder:
A list of available sonar modules is displayed.
3. Select the Sonar module from the list that you
want to display in the Fishfinder application.
Operation instructions
For detailed operation instructions for your product,
refer to the documentation that accompanies your
display.

6.2 Troubleshooting

The troubleshooting information provides possible
causes and corrective action required for common
problems associated with marine electronics
installations.
All Raymarine products are, prior to packing and
shipping, subjected to comprehensive test and
quality assurance programs. However, if you
experience problems with the operation of your
product this section will help you to diagnose
and correct problems in order to restore normal
operation.
If after referring to this section you are still having
problems with your unit, please contact Raymarine
Technical Support for further advice.
CP100 / CP200