Table of Contents
Advertisement
10.8
AXIS-SPECIFIC SCALING (Cycle 26)
Effect
With Cycle 26 you can account for shrinkage and oversize factors
for each axis.
The SCALING FACTOR becomes effective as soon as it is
defined in the program. It is also effective in the Positioning with
manl.data input mode of operation. The active scaling factor is
shown in the additional status display.
Resetting
Program the SCALING cycle once again with a scaling factor of 1
for the same axis.
Please note while programming:
Coordinate axes sharing coordinates for arcs must be
enlarged or reduced by the same factor.
You can program each coordinate axis with its own
axis-specific scaling factor.
In addition, you can enter the coordinates of a center
for all scaling factors.
The size of the contour is enlarged or reduced with
reference to the center, and not necessarily (as in
Cycle 11 SCALING FACTOR) with reference to the
active datum.
HEIDENHAIN | TNC 320 | User's manual for cycle programming | 9/2016
AXIS-SPECIFIC SCALING (Cycle 26) 10.8
10
263
Advertisement
Table of Contents
