Axis-Specific Scaling (Cycle 26); Effect; Please Note While Programming - HEIDENHAIN TNC 620 User Manual

Hide thumbs Also See for TNC 620:

Table of Contents

AXIS-SPECIFIC SCALING (Cycle 26)

With Cycle 26 you can account for shrinkage and oversize factors

for each axis.

The SCALING FACTOR becomes effective as soon as it is defined

in the program. It is also effective in the Positioning with MDI

mode of operation. The active scaling factor is shown in the

additional status display.

Program the SCALING cycle once again with a scaling factor of 1

for the same axis.

Coordinate axes sharing coordinates for arcs must be

enlarged or reduced by the same factor.

You can program each coordinate axis with its own

axis-specific scaling factor.

In addition, you can enter the coordinates of a center

for all scaling factors.

The size of the contour is enlarged or reduced with

reference to the center, and not necessarily (as in

Cycle 11 SCALING) with reference to the active

HEIDENHAIN | TNC 620 | User's manual for cycle programming | 9/2015

AXIS-SPECIFIC SCALING (Cycle 26) 10.8