Table of Contents
Advertisement
Use manual configuration
Set the NVR to use static IP
1) Built-in DHCP server should be turned on when this mode is selected.
2) Use the NVR's default static IP when this mode is selected.
3) Users can change the IP settings
Users can turn on/off built-in DHCP server.
You need to adjust settings on this page for the device to work properly in your network. It is
critical that settings here are configured correctly based on your network configurations so that
the recorder can be administered through the local area network and cameras can be
connected from it.
By default, the recorder is set to "Set network automatically" which if there's a DHCP server in
the same local network, the NVR can obtain IP address from DHCP server, and you can locate
the NVR by using the NVR search utility.
If there's no DHCP server in the network, and the NVR is set to enable DHCP server, it will use
its own default static IP 192.168.0.20.
If you wish to set the recorder to a static IP address in your local area network,
1.
Choose "Use manual configuration"
2.
Enter the IP address, subnet mask, default gateway address and DNS server address for
the recorder
* The recorder can detect the presence of a DHCP server upon startup. It sets itself to static IP
address if there is no DHCP server currently presented in the network. Its DHCP server function
is also turned on at the same time to assign IP addresses to cameras that are later connected to
the network or you can manually turn off the DHCP server function if you wish to use a separate
DHCP server.
32-Channel Network Video Recorder
NVR-3210/NVR-3250/NVR-3280
50
Advertisement
Table of Contents
