Table of Contents
Advertisement
4079-00X
Be sure there is no obstruction in the carriage drive path and that the
print timing slit is not dirty, broken, or bent. Use a cleancloth to clean
the timing slit. If the drive path is obstructed, clear the obstruction,
then run POST to check the printer.
FRU
1
Carriage
Cables
2
• Linear
Encoder/
Paper Width
Sensor
• Carriage
Board
• Logic Board
2-42
Action
Check the continuity of the brown carriage cables.
Replace the cables if necessary.
Remove and replace the following parts in the order
shown. Check the printer after each replacement to
see if the problem is solved.
1. Linear Encoder/Paper Width Sensor
2. Carriage Board
3. Logic Board
If you replace the logic board, go to the
Adjustment Mode" on page 4-4
position adjustment, and the direction offset adjust-
ment.
"Service
and perform the print
Advertisement
Table of Contents
