Table of Contents
Advertisement
4079-00X
10.Disconnect the ink lines from the carriage to the ink cartridge
assembly (2) and hook the drain joint holder in the holes pro-
vided on the carriage frame.
11.Remove the carriage card holder cover.
12.Disconnect the two carriage ribbon cables and slide the cables
out of the carriage.
13.Remove the carriage card holder and the carriage card.
14.Remove the encoder and paper width sensor assembly.
15.Separate the ink joint holder from the end of the ink supply joint.
When possible, wrap ends of ink lines in a cloth or packet of
paper towels and secure with a rubber band to prevent ink spill-
age.
16.Carefully feed the tubes through the side frame and remove the
carriage ink supply assembly. Be aware that the ink can stain
clothing and furniture.
Note: Keep the ink supply assembly level to prevent ink leaking
from the printhead connections. Discard the ink supply in a plastic-
lined waste can or heavy plastic bag.
Installation Notes: When replacing the carriage ink supply or car-
riage frame:
1. Check the
2. Check the
checked:" on page
"Head Gap Adjustment" on page
"The registration of the four color printheads must be
4-6.
4-2.
Repair Information
4-26
Advertisement
Table of Contents
