Table of Contents
Advertisement
Product Installation Guide
The slim pad is an extremely thin product under 0.2 (5mm), so please install a thick pad
or bedding under the pad when using on the oor in order to prevent loss of cushioning
and heating.
1. Put the cover on the pad.
If there is no cover, put a pad or blanket over the pad.
Using without a cover or pad for a long period of time can cause a mild burn.
2. Select the location of usage.
Place the host of the pad toward the feet, and leave the space
between the heating unit and the pad over 1 ft. (30cm)
Electromagnetic waves may occur from the heating unit.
Placing the heating unit at the same height as or slightly
higher than the pad is preferred.
3. Connect the heating unit and the hose of the pad.
Lay down the hose of the pad at facing the Navien Logo
upward without tangling, and push the pad hose connector to
the back of the heating unit water outlet/inlet connector rmly
all the way until you hear a click sound.
4. Connect the power cord of the heating unit to the power
outlet and touch the power button to turn on.
Er 02 (water shortage error code) will be displayed and the water level lamp and inspection
lamp will be turned on when you use it for the rst time.
5. Fill the heating unit with water.
Prepare the water.
(The amount of water to be lled is 1,500
1,300
for queen size, and 1,100
Pull the water inlet cover and turn the water cap
counterclockwise to open.
Check the water level lamp and slowly pour down the water.
If the 4th-level water lamp is on, stop lling the water and wait
for a little bit. (Wait until the water moves toward the pad.)
When the 1st water level lamp blinks again, ll the water until
the 4th water level lamp is turned on.
After water lling is complete, close the water cap by turning
it clockwise until there is a "click" sound, and close the cover.
If the water touches the safety net inside the water inlet, it can over ow.
Be careful to keep the water level low enough to prevent it from touching the safety net.
If excessive water is lled after completing water replenishment, be aware of the possibility
of water leaking from the small air holes on the water inlet cap.
Filling water over the 3rd-level is recommended for a continuous and stable heating.
(If there is a lack of water, noise may occur.)
A water shortage error (Er 02) may occur when lling the water for the rst time.
(Fill the water slowly)
6. Set a desired temperature and start using.
Refer to the "Product Operation" page for instructions on setting the temperature.
14
for king size,
for single size.)
1ft
click!
1
2
click!
Hide quick links:
Advertisement
Table of Contents
