Headlamp Housing – Intrepid; Fog Lamp Housing; Roll Fascia Forward; Remove Headlamp Housing - Chrysler 2000 LHS Owner's Manual

8L - 20 LAMPS
REMOVAL AND INSTALLATION (Continued)
Fig. 5 Roll Fascia Forward
1 – ROLL FORWARD
Fig. 6 Remove Headlamp Housing
1 – REMOVE HEADLAMP HOUSING
HEADLAMP HOUSING – INTREPID
Headlamp lens fogging is a normal condition
and does not require service unless excessive
or continual. Moisture will vent from tubes or
vents located on the back of the lamp.
REMOVAL
(1) Release hood latch and open hood.
(2) Remove jackscrews attaching headlamp to body
(Fig. 7).
(3) Remove headlamp from body.
(4) Disconnect wire connector from headlamp and
parking, side marker, and turn signal lamps.
(5) Remove headlamp housing from vehicle.
Fig. 7 Headlamp Housing – Intrepid
1 – JACKSCREW
2 – HEADLAMP HOUSING
3 – BODY WIRE CONNECTOR
INSTALLATION
(1) Place headlamp housing in position on vehicle.
(2) Connect wire connectors to headlamp, parking,
side marker, and turn signal lamps.
(3) Place headlamp in position on body.
(4) Install screws to attach headlamp to body.
(5) Verify headlamp operation and alignment.

FOG LAMP HOUSING

REMOVAL
(1) Remove screw(s) attaching fog lamp to fascia
(Fig. 8), (Fig. 9), and (Fig. 10).
(2) Pull fog lamp forward from opening in front
bumper fascia.
(3) Disconnect fog lamp wire connector from front
lighting wire harness.
(4) Remove fog lamp from vehicle.
INSTALLATION
(1) Place fog lamp in position on vehicle.
(2) Connect fog lamp wire connector to front light-
ing wire harness.
(3) Insert fog lamp rearward into opening in front
bumper fascia.
(4) Install screw(s) attaching fog lamp to fascia.
(5) Verify fog lamp operation and alignment. Refer
to Fog Lamp Alignment procedures in this group.
LH