Table of Contents
Advertisement
CS
HEADLAMP (Continued)
IGNITER
Make sure the slots on the igniter are lined up. If
not, use a small screwdriver to align them (Fig. 20).
Fig. 20 IGNITER UNDERSIDE
1 - IGNITER RETAINING HOOKS
(1) Place the igniter on the HID lamp. Do not at
this time connect the igniter electrical connector. It
will make it unable to twist the igniter to the closed
position.
(2) Twist the igniter clockwise to close/lock it into
place.
(3) Position the igniter electrical connector and
firmly snap into place (Fig. 21).
Fig. 21 IGNITER ELECTRICAL CONNECTION
LAMPS/LIGHTING - EXTERIOR 8L - 17
(4) Install the rubber boots/seals protecting the
lamp/igniter from the elements.
(5) Install the headlamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - INSTALLATION).
BALLAST MODULE
(1) Place the ballast module on the headlamp unit
(Fig. 19).
(2) Install the three retaining screws (Fig. 18)
(3) Install the headlamp unit (Refer to 8 - ELEC-
TRICAL/LAMPS/LIGHTING
LAMP UNIT - INSTALLATION).
HEADLAMP UNIT
STANDARD PROCEDURE - HEADLAMP UNIT
ALIGNMENT
HEADLAMP UNIT ALIGNMENT PREPARATION
(1) Verify headlamp dimmer switch and high beam
indicator operation.
(2) Inspect and correct damaged or defective com-
ponents that could interfere with proper headlamp
alignment.
(3) Verify proper tire inflation.
(4) Clean headlamp lenses.
(5) Verify that luggage area is loaded as the vehi-
cle is routinely used.
(6) Vehicles equipped with automatic load leveling
suspension should be driven normally for approxi-
mately 5 km (3 miles) before attempting a proper
headlamp unit alignment.
(7) Fuel tank should be FULL. Add 2.94 kg (6.5
lbs.) of weight over the fuel tank for each estimated
gallon of missing fuel.
-
EXTERIOR/HEAD-
-
EXTERIOR/HEAD-
Advertisement
Table of Contents
