Pfaff 3371-1 series Adjustment Manual page 7

Fine adjustment
Switch on the machine.
In the input mode, select parameter "608", see Chapter 11.03 Parameter input in the
instruction manual.
If necessary, enter the access code, see Chapter 11.04.01 Entering the access code in
the instruction manual.
With the corresponding plus/minus key move the work clamp drive unit in accordance
with requirement 1, also see Chapter 11.03 Parameter input.
Switch off the machine.
Remove adjustment gauge 1.
Fit the lower feed plate and work clamp holder.
If, during the fine adjustment, the setting is ± 5 increments above or below the
value in X- and Y-direction, the setting should be checked again in accordance
with requirement 2.
Adjustment
14 - 4